project
Find What Suit to Your Project
Precast Mould
position :
Long Line Method of Precast Segmental Bridge Girder Formwork
Huada Heavy Industry designs and export one set of precast segment bridge girder formwork to Colombia for highway bridge construction.

23th September, 2015, the precast segment bridge girder formwork were transported to the construction site. This design adopts the long line construction method. Our senior engineer and installation engineer arrive at the construction site for guidance on November 5 .

Long line method of precast segment bridge girder formwork:
Production methodology
Both elongation length and prestress force can be used to check that the correct stress levels are achieved. This cross-checking process ensures a safer, more controlled production process.
Efficiency
Long-line production generally uses less staff and materials.

Huada Heavy Industry Long-line method of precast segment bridge girder formwork with consistent quality and generally lower costs than the short-line method, and is generally more cost effective.

Segmental Bridge Formwork
Segmental Bridge Formwork
Segmental Bridge Formwork
related products
    Tyre Transporter
    Tyre Transporter
    Huada Heavy Industry also specializes in the design, manufacturing and supply of Transporters for transportation of precast full span girder, pre-cast segment or other structures. These Tyre Transporters' lifting capacities normally range from 50t to 900
    See Detail
    Straddle Carrier
    Straddle Carrier
    Straddle Carriers are basically lifting cranes mounted on tyres often used to replace gantry cranes for lifting and handling heavy loads in casting yards, factories, storage areas, ports...
    See Detail
    Segment Box Girder Mould
    Precast Mould
    Huada Heavy Industry designs and builds Segment Box Girder Moulds for Full Span, Long Line and Short Line methods of casting for single, double, or triple Box Girder...
    See Detail
    Gantry Crane
    Gantry Crane
    Huada Heavy Industry Gantry Crane, are designed for a comprehensive use in the fabrication industry including casting yard or fabrication yard and most of the case it is outdoor usage. Standard and special portal cranes are manufactured and supply by Huad
    See Detail
    Overhead Segmental Launching Gantry
    Overhead Segmental Launching Gantry
    Precast Segmental Method with a Segmental Launching Gantry (LG) is a very popular way used for the construction of bridges and viaducts with small curve and long span...
    See Detail
    Underslung Segmental Launching Gantry
    Underslung Segmental Launching Gantry
    Precast Segmental Method with a Segmental Launching Gantry (LG) is a very popular way used for the construction of bridges and viaducts with small curve and long span...
    See Detail
    Beam Launcher
    Beam Launcher
    Beam Launcher is widely used for erection of precast concrete girders with almost all types of cross-sections, including I-beams, T-beams, U-beams, etc., It is designed for highway and railway...
    See Detail
    Full Span Launching Gantry
    Full Span Launching Gantry
    The equipment was developed and designed by our Huada Heavy Industry Design Department for high speed railway bridge and cross-sea bridge construction by full span launching method (commonly known as FSM)...
    See Detail
    Inquiry
    If you have any questions about our products, please contact us in time, we will reply to you the first time
    Name :
    * Email :
    Tel :
    Country :
    * Messages :
    Send
    Reset
    Top